24H Service:
+86-13585569799
Your Position: Home > Product >

Replacement of sand with marble powder in green concrete

  • Partial Replacement of Cement With Marble Powder in Concrete

    Partial replacement of marble powder in cement accordingly in the range of 20%, 30%, 40%, by weight for M20 grade of concrete. With this experimental research work the problem of waste production management of this agro waste are will be solved.

  • Best Or Partial Replacement Of Sand In Concrete

    Partial Replacement of Cement With Marble Powder in Concrete. Concrete Mix Design The concrete used in this research work was made using Binder, Sand and Gravel. The concrete mix proportion was 124 by weight. Test specimens Test specimens consisting of 150150150 mm cubes for Compressive strength, 150mm dia,

  • Synergistic Effect of Marble Powder and Green Sand on the

    The mechanical properties of the hardened concrete made of green sand and marble powder were studied at various ages. The microstructure and hydration products were also investigated to assess the impact of using green sand on marble powder as partial replacement for fine aggregate. 2. Materials and Methodology Ordinary Portland cement (OPC

  • Green Concrete: Using Industrial Waste of Marble Powder

    Water used for manufacturing of Green concrete is potable and uniform, simply a tap water. WASTE PAPER PULP: Paper pulp from paper industry, marble powder from marble cutting and artistic thing of marble, quarry dust from mining industry are being used in green concrete. About 300 kg of pulp waste is produced for each tone of recycled paper [7].

  • Replacement of cement and sand in concrete with Waste

    aggregate with marble dust powder or marble waste. 2. 10% replacement of sand with marble dust powder. 3. 10% replacement of cement with marble dust powder. 10% sand and 10% cement both are replaced with marble dust powder.. TABLE I Sr. No Cement % Sand % Marble powder % Mix Designation 1 100 100 0 Mix0 (control) 2 100 90 10 Mix1 (Sand)

  • Experimental study on concrete using waste marble powder

    Since this concrete is prepared with marble powder as a partial replacement of fine aggregate (Sand) in four different proportions i.e. 10%, 15 % ,20% and 25 % and tested for the period of 7days, 14 days and 28 days. This compressive strength is compared with the conventional concrete i.e. concrete prepared without marble powder.

  • " Green Concrete: Using Industrial Waste of Marble Powder

    From the above study, it is concluded that the quarry rock dust and marble sludge powder may be used as a replacement material for fine aggregate. The replacement of fine aggregate with 50% marble sludge powder and 50% Quarry rock dust (Green concrete) gives an excellent result in strength aspect and quality aspect.

  • Review on the feasibility of Marble Dust as Replacement of

    waste marble powder construction industry itself as fine aggregate replacing natural sand in concrete. The replacement is done partially and fully in the proportion 0%, 25%, 50% and and its effect on concrete properties were analyzed and outcomes that replacement of 50% of sand with marble powder is

  • Synergistic Effect of Marble Powder and Green Sand on the

    Feb 04, 2019· The aim of this paper is to study experimentally the effect of marble powder and green sand as partial substitute for fine aggregate on the strength and durability of M40 grade concrete. The use of metakaolin as a pozzolanic admixture by using as binder replacement is also studied to assess the properties with respect to fresh and hardened state.

  • Review Paper On Effective Partial Replacement Of Cement

    Review Paper On Effective Partial Replacement Of Cement And Sand With Fly-Ash And Marble Powder To Make Green Concrete Darzi Musaib A.1,Bhumre Shivkumar2, Kamble Ashok3, Giri Sunil C.4, Kamble Rupesh5, Seham Khaleel6 1 BE Student, Department of civil Engineering, Sinhgad Academy of Engineering, Pune, India.

  • Replacement of Fine Aggregates by Mixture of Ceramic

    ceramic and marble powder the compressive and tensile strength of the concrete mix increased, with its maximum value at full replacement of conventional fine aggregate by ceramic and marble powder. Keywords: Compressive strength, Split cylinder test, Slump test, Water-Cement ratio, Ceramic and marble mixture, Mix design.

  • Use of Waste Marble Powder as Partial Replacement in

    marble dust powder on the concrete mix by partially replacing cement and sand with the marble powder dust. In this project, we check the effect on mechanical and physical properties of a concrete mix if varying marble powder dust is partially replaced in the concrete mix. 1.1 Research Significance

  • Marble Powder As A Partial Replacement Of Sand - 1454

    This has made prices of Natural sand reach its peaks. Now there is every need for a suitable replacing material for Natural sand. An attempt is made in this context to replace natural sand by Granite fines by adopting M20 Grade concrete with a mix design of 1: 1.73: 3.1 of cement: Natural sand& Granite Powder : Gravel

  • Project on Partial Replacement of Cement with Marble Powder

    QUANTITY OF MARBLE POWDER; 5% of cement replaced by marble powder = 377.38gm 10% of marble powder = 754.7 gm 15% of marble powder = 1.13 kg 20 %of marble powder = 1.5094 kg. Experimental conditions: Compressive strength of concrete was undertaken on 15 cm cubic specimens. at 7 days and 28 days of age.

  • STRENGTH AND DURABILITY PROPERTIES OF CONCRETE

    Key Words: Metakaolin, Marble Powder, Compressive strength, Split-Tensile strength. 1. INTRODUCTION 1.1 General In construction Industry, consumption of cement is increasing day by day as well as cost is also increasing so to reduce the consumption of cement, partial replacement with Metakaolin and Marble powder was done in this study.

  • (PDF) Evaluation of Concrete with Partial Replacement of

    In this study, use of glass powder and marble powder as partial replacement of cement in various proportions (5%, 10%, and 15% by weight) in manufacturing of non-load bearing hollow concrete

  • Study of Properties of Concrete using Marble Powder and

    [1] Nitisha Sharma studied the properties of Waste Marble Powder as a Partial Replacement in Cement Sand Mix This was done by replacing cement by a percentage of marble powder. Four basic concrete mixes were considered. When cement is replaced with marble powder up to 10% weight, high strength concrete was achieved.

  • Experimental Utilization of Marble Dust Powder as Partial

    Aliabdoet.al. [12], studied the replacement of cement or sand by marble powder for improvement in concrete properties. It shows that sand replacement gives better results as compare to cement replacement. Also, AlirezaNaji et al. [9], studied that average particle size of rice husk provides positive effect on compressive

  • Partial Replacement of Fine Aggregates with Quarry Dust

    river sand. Quarry dust and Marble powder contains similar properties as that of river sand and hence accepted as a building material. The present paper focuses on investigating maximum percentage replacement of river sand by Quarry dust and Marble powder in varying equal percentages 0%, 10%, 20%, 30%, 40%, 50%, and 60% for M25 mix designations.

  • Partial replacement of sand with marble waste and scoria

    Nov 02, 2020· Sand is used more than any other natural resources except water and air, However, its extracted at a rate far greater than its renewal. The availability of sand in the growing demand of the construction industry will be a challenge due to a wide range of variability, cost, and, quality problems. This study aims to investigate normal strength concrete by partially replacing sand with

  • Development of green concrete using waste marble dust

    Jan 01, 2020· Marble mud powder can be used as a filling assist and leads to can complete voids of concrete construction. This paper shows how to use a 100 percent alternative to natural sand in concrete with the marble mud dust. This research examined the strength of compression and the microstructure of mixed cement.

  • An Experimental investigation on strengths characteristics

    characteristics of concrete using as a partial replacement of cement by marble dust powder and sand by stone dust. The Dissertation work is carried out with M 30 grade concrete for which the marble powder is replaced by 0%, 5%, 10%, 15%, 20% by weight of cement. For all the mixes compressive,

  • Use of Waste Marble Powder as Partial Replacement in

    May 18, 2015· It can be observed that the flexure strength for the concrete mix containing 10% of marble powder dust in cement got increased by the value of 9.2% and for 10% replacement with sand the flexure strength also got increased about 9.3% but it decreased when the mix contains 20% marble powder dust against cement (10%) and sand(10%) about 10%.

  • Evaluation of Concrete with Partial Replacement of Cement

    This study aims to evaluate concrete having Waste Marble Powder (WMP) as partial replacement of cement. Marble is the metamorphic form of limestone (CaCO 3) and WMP was chosen as substitute of cement on account of its high calcium oxide content.WMP is by-product of marble industry and is an environmental burden.

  • UTILIZATION OF WASTE QUARRY DUST AND MARBLE

    incorporating marble powder as partial sand substitute. Corinaldesi et al. (2010), found that at same workability, marble powder showed high strength at 10% sand substitution. This research aims at utilization of waste marble powder and quarry dust in concrete as partial replacement of sand.

  • Influence of Marble Dust as Partial Replacement of Cement

    replacement, mix was prepared with cement and sand blended with marble dust with replacement from 10%, 20%, 25% and 30%.The investigation indicates that replacement of cement by marble waste powder at different ranges, in concrete production, results in higher compressive strength, split tensile strength and flexural strength as of concrete

  • Synergistic Effect of Marble Powder and Green Sand on the

    The aim of this paper is to study experimentally the effect of marble powder and green sand as partial substitute for fine aggregate on the strength and durability of M40 grade concrete. The use of metakaolin as a pozzolanic admixture by using as binder replacement is also studied to assess the properties with respect to fresh and hardened state.

  • (PDF) EFFECT OF QUARRY DUST AS PARTIAL REPLACEMENT OF SAND

    Also, the use of quarry dust as the fine aggregate decreases the cost of concrete production in terms of the partial replacement for natural river sand. Design mix of M25grade concrete with

  • Use of Marble Powder and Tile Powder as Cementitious

    M. M. Ali, S. M. Hashmi, An experimental investigation on strengths characteristics of concrete with the partial replacement of cement by marble powder dust and sand by stone dust, International Journal for Scientific Research & Development, Vol. 2, No. 7, pp. 360-368, 2014

  • PARTIAL REPLACEMENT OF CEMENT WITH MARBLE DUST

    replacement of Cement with Waste Marble Powder Partial replacement of cement by varying percentage of marble powder reveals that increased waste marble powder (WMP) ratio result in increased strengths of the mortar and concrete Thus they found out the optimum percentage for replacement of MDP with cement and it is almost 12.5

  • Influence of Marble Powder Mortar and Concrete Mix

    The use of waste marble powder (dust) was proposed in partial replacement of cement, for the production of Mortar and Concrete Mix. In particular, tests were conducted on the mortars and concrete mix cured for different times in order to determine their workability, flexural as

  • Use of Waste Marble Powder as Partial Replacement in

    May 18, 2015· It can be observed that the flexure strength for the concrete mix containing 10% of marble powder dust in cement got increased by the value of 9.2% and for 10% replacement with sand the flexure strength also got increased about 9.3% but it decreased when the mix contains 20% marble powder dust against cement (10%) and sand(10%) about 10%.

  • Study of Properties of Concrete using Marble Powder and

    [1] Nitisha Sharma studied the properties of Waste Marble Powder as a Partial Replacement in Cement Sand Mix This was done by replacing cement by a percentage of marble powder. Four basic concrete mixes were considered. When cement is replaced with marble powder up to 10% weight, high strength concrete was achieved.

  • Synergistic Effect of Marble Powder and Green Sand on the

    Feb 04, 2019· The aim of this paper is to study experimentally the effect of marble powder and green sand as partial substitute for fine aggregate on the strength and durability of M40 grade concrete. The use of metakaolin as a pozzolanic admixture by using as binder replacement is also studied to assess the properties with respect to fresh and hardened state.

  • Investigation on Strength Properties of Concrete with

    3.5 Marble Powder The specific gravity of marble is 2.577. Local available marble powder used as partial replacement of fine aggregate in concrete. 3.6 Granite Powder Granite belongs to igneous rock family. Granite powder obtained from the polishing units and the properties were found.

  • Partial Replacement of Cement with Marble Dust Powder

    Experimental Study on Partial replacement of Sand with Marble Dust Powder in high strength concrete Deepankar Kumar Ashish , K. Verma , R. Kumar , Nitisha Sharma , G. Pathan 2018

  • Durability of Concrete made with Marble Dust as partial

    The authors showed that up to 10% of marble dust can be used as replacement of cement with 21.22 % increase in the strength of concrete. According to Hanifi Binici et al., the durability of the concrete made up of marble and GBFS was found to be more advanced than the concrete made up of Portland cement.

Online Consultation Contact Details QR Code

Service Hotline

+86-13585569799

Scan to contact us