24H Service:
+86-13585569799
Your Position: Home > Product >

Protex sand float finish interior latex high

  • FINISHING AND REFINISHING INSTRUCTIONS for Interior and

    easy to sand through the veneer. Do not sand veneers any more than necessary. Stile and rail doors have wood panels that can float. If necessary, adjust panels before finishing by carefully realigning with a wood block and hammer. FINISH THE DOOR Use the table below to find your product and desired finish and follow the instructions in the

  • Interior System Evaluation 9.2 INT 9.2 PLASTER AND

    Interior System Evaluation 9.2 INT 9.2 PLASTER AND GYPSUM BOARD for a smooth surface; Floated or Sand Float finish - low stipple texture; Spray texture finish - smooth to moderately rough spatter High Performance Architectural Latex is a high performance system, which provides a significant benefit in the areas of scrub

  • How to Apply Sand-Textured Paint Home Guides SF Gate

    Jul 21, 2017· A 10 to 1 sand to paint ratio is recommended, with more or less sand added depending on the texture you desire. You can elect to make patterns in sand-textured paint

  • 6 Secrets to Silky Smooth Paint The Craftsman Blog

    May 25, 2015· Sand any bare wood to 120-grit and no finer. This will give the primer good tooth to hold on and create the right base to start with. A good paint job is all in the prep before you even touch a paint brush. 2. Sand Your Primer. Without a smooth base, you cant get a smooth finish. I always use oil-based primer on woodwork and cabinets

  • How to Prepare Walls for Painting Benjamin Moore

    Smoothing walls before painting is necessary for surfaces previously painted with a gloss or high-gloss paint. For previously painted water-based paint, sand with a fine-grit sandpaper. For oil-based paint, a medium-grit sandpaper (100- to 150-grit) should be used. Again, wipe away any debris and allow to

  • How to Prepare your Boat for Painting a Gelcoat - Sail

    Apr 15, 2015· Once the imperfections have been filled, apply one to two coats of a high-build primer and then one to two coats of a finish primer. Final sanding of the finish primer should be done with 320- to 400-grit sandpaper. After sanding, wipe off the residue. Once the surface has been sanded and cleaned, apply two to three coats of finish.

  • Do you wet sand primer before painting?

    May 03, 2020· Most latex primers dry to the touch within 30 minutes to 1 hour. But do not paint the wall until the primer dries thoroughly, which can take up to 3 hours. High humidity and cool temperatures prolongs drying times.

  • ProTex Interior Latex High Build Sand Float Finish Wall

    Sand Float Finish provides a decorative sand-like finish that hides wallboard tape joints, nail heads and minor surface imperfections. Safety Data Sheets (SDS) To read PDF files, you need the Adobe Acrobat Reader 6.0 or higher. Click here to download it for free

  • Shellac as a paint primer - FineWoodworking

    Mar 13, 2008· Of course you could sand it all for "tooth" which then reopens your bleed through factor. Primers act as a binder to the shellac and offer a grabby surface to the finished paint. My experience is that shellac alone as a primer under latex may lead to long term latex adhesion failure. Just my experience. I just do it (shellac) on trouble spots.

  • Duration Home® Interior Acrylic Latex Paint - Sherwin-Williams

    Now available in matte, satin and semi-gloss finishes, Duration Home features exclusive cross-linking technology that actually repels stains. With excellent washability and high-hiding accent bases, it's easy to apply, goes on smoothly and offers an excellent hide.

  • How can I smooth rough latex paint before repainting

    Dec 28, 2014· The finish is somewhat shiny (maybe semi-gloss, maybe eggshell). When I've tried sanding latex paint in the past, it just turned to goo and clogged up the sand paper. (The paint is recent enough that I'm confident there is no lead in it.) I'd skim coat with wall compound but I'm afraid it won't stick to the shiny finish.

  • ProTex Interior Latex High Build Sand Float Finish Wall

    ProTex Interior Latex High Build Sand Float Finish Wall & Ceiling Paint - 1 gal. Model Number: 9700-11-01 Menards ® SKU: 5591206 Variation drop down Size: Gallon Size: 5 Gallon

  • Product FAQs General Finishes

    GF has two products that would work well. For non-professional finishers, we recommend using General Finishes Arm-R-Seal Topcoat.. Arm-R-Seal is oil based and will amber. Be sure to apply liberally with a foam brush or roller, letting the product self-level a bit.

  • How to Correct Paint Imperfections in Drywall Home

    Dec 14, 2018· Semi-gloss and high-gloss paint are extremely reflective. Both tend to highlight imperfections rather than hiding them. Avoid using either finish on walls that are not in excellent shape.

  • Technical Information Protex Sand Float Finish Interior

    Protex Sand Float Finish Interior Latex Wall & Ceiling Paint provides a decorative sand-like finish that hides minor surface imperfections. This ready-mix sand float finish paint is self-priming over new drywall and may also be applied to plaster, masonry, wood,

  • Conco Paints - Interior ProTex(TM) Textured Coatings

    ProTex Sand Float Finish Interior Latex Wall and Ceiling Paint A decorative, sand-like finish for walls & ceilings, ProTex Sand Float Finish helps hide nail

  • Drywall Primer Basics and Application - The Spruce

    Sep 16, 2020· Hiding paints take the concept of flat latex paint one step further. This product is still a flat latex paint, but it is slightly thicker and has better color-hiding properties than plain latex paint. Make sure to choose a hiding paint that is compatible with unfinished drywall. Hiding paints may cost up to twice as much as ordinary flat latex

  • Stucco Textures And Finishes, A Visual Aid And Insight

    Sand/Float Finishes: This is a basic and simple kind of texture that is popular in commercial applications. It can be fine, medium or coarse in appearance and varies depending on the manufacturer. It is troweled down and finished using a float and quick strokes.

  • Homax Sand Texture Paint Additive-8474 - The Home Depot

    Create a sand texture on indoor or outdoor wall and ceiling surfaces with the Homax Products 6-oz. Sand-Texture Paint Additive. This additive mixes with a gallon of paint or stain to provide sand texturing to a wide variety of surfaces, including wood, brick, plaster and concrete.

  • ARDEX Products: High Performance Flooring and Tiling Products

    High-performance, high solids, waterborne, acrylic concrete sealer Seals and protects all uncoated cementitious surfaces, including ARDEX Toppings Durable and abrasion-resistant on interior and exterior absorbent concrete and masonry surfaces

  • Protex Sand Float Ceiling Paint

    Paintdocscom protex sand float finish interior latex wall ceiling paint protex sand float finish interior latex wall ceiling paint provides a decorative sandlike finish that hides minor surface imperfections this readymix sand float finish paint is selfpriming over new drywall

  • 971 SERIES Protex Sand Texture Interior Latex Wall

    Protex Sand Texture Interior Latex Wall & Ceiling medium sized orifice and a very high air pressure. For a splatter effect, use a large and reduced air pressure. May be thinned with up to 1/2 cup of water per gallon for spray application. Roller Apply sand float finish with a 1/2 nap synthetic r in 3 x 3 sections at a time

  • Preservation Brief 21: Repairing Historic Flat Plaster

    For example, fine white sand was mixed in for a "float finish." This finish was popular in the early 1900s. (If the plasterer raked the sand with a broom, the plaster wall would retain swirl marks or stipples.) Or marble dust was added to create a hard-finish white coat which could be smoothed and polished with a

  • Spray Paint vs. Brush Hand Painting on Interior Doors

    Feb 04, 2021· If you choose to use a latex paint, start by making sure it is a reputable paint brand. Then, for an extra smooth finish, consider adding a latex paint conditioner like Floetrol. This is optional, but adding a paint conditioner slows drying times for latex paint to make it more comparable to oil based options, but without the hassle and odor.

  • Repairing Historic Flat Plaster Walls and Ceilings - Old

    Oct 11, 2016· For example, fine white sand was mixed in for a float finish. This finish was popular in the early 1900s. (If the plasterer raked the sand with a broom, the plaster wall would retain swirl marks or stipples.) Or marble dust was added to create a hard-finish white coat which could be smoothed and polished with a steel trowel.

  • Conco Paints - Home

    low VOC level, ProTex Sand Float Finish meets or exceeds VOC regulations in every region of the United States. Spray, brush or roll. The choice is yours. However you choose to apply ProTex Sand Float Finish, the result will be a great finish that won't run or sag even with an applied film thickness of 8 mils. It also offers a high count of

  • 2 gal. White Sand Roll-On Texture Decorative Wall Finish

    Homax Sand Roll-On Texture is a ready-to-use, easy-to-apply, low odor, paintable finish for interior walls and ceilings. It is ideal to refresh surfaces, or to create a distinct decorative effect to beautify your home. Homax Sand Roll-On Texture contains a lightweight perlite

  • Homax 41072024174 Roll On Wall Texture White, Sand, 2 gal

    Homax Sand Roll-On Texture is a ready-to-use, easy-to-apply, low odor, paintable finish for interior walls and ceilings. This low odor, paintable formula is ideal to refresh surfaces, or to create a distinct decorative effect to beautify your home. Add depth and dimension with unique texture patterns. Hides surface imperfections too.

  • Paintable Vinyl Corner Guards Wall Protection Wallprotex

    Sand or scuff the surface of the corner guard using 120 grit sandpaper or a scouring pad 2. Any water based paint including acrylic or latex is a good choice. While any type of sheen will work, a semi-gloss or high-gloss finish paint can help hide scuffs and scratches. Check with your local paint supplier for recommendations.

  • Interior Texture Sprayers - Graco

    High-quality and reliable Graco interior texture sprayers have set the standard for professional contractors for 25 years. Whether you're spraying skim coat, drywall mud in an orange peel, splatter or knockdown finish or other heavy coatings, we have a sprayer designed to produce any finish needed.

  • Conco - Interior Contractor Paint at Menards®

    ProTex Interior Latex High Build Sand Float Finish Wall & Ceiling Paint. Click to add item "ProTex Interior Latex High Build Sand Float Finish Wall & Ceiling Paint" to the compare list.

  • Conco Paints - ProTex

    ProTex Sand Float Finish. ProTex Sand Float Finish creates a beautiful textured finish ideal for both walls and ceilings. Perfect for residential, commercial and institutional applications, it lends a unique look to any environment.

  • What is a Level 5 Drywall Finish?

    What is a level 5 finish? The Gypsum Association, founded in 1930, is made up of some of the most well known gypsum board manufacturers and retailers in North America.The Gypsum Association publishes much information for architects, builders, distributors and others on the subject of gypsum materials.

  • 970 0 CEILING PAINT PROTEX SAND FLOAT FINISH

    1 coat ProTex 9700 Sand Float Finish Interior Latex Wall & Ceiling Paint Wood 1 coat Conco ® P007 All Surface Interior/Exterior Acrylic Stain Blocking

Online Consultation Contact Details QR Code

Service Hotline

+86-13585569799

Scan to contact us